1. تعارف
This manual provides detailed instructions for the safe and effective operation of the ES 725 Battery/Starting/Charging Tester. The ES 725 is designed to test 6 and 12-volt batteries, as well as 12 and 24-volt charging systems. It performs a guided test sequence covering battery condition, cranking volts, and the overall charging system, including alternator voltage and AC ripple for bad diodes.
2. حفاظتی معلومات
Always observe the following safety precautions when using the ES 725 Tester:
- Wear appropriate eye protection (safety glasses) and protective clothing.
- Ensure adequate ventilation when working with batteries, as they can produce explosive gases.
- Avoid sparks or open flames near batteries.
- لائیو الیکٹریکل پرزوں کو مت چھونا۔
- ٹیسٹر کو خشک اور صاف رکھیں۔ اسے بارش یا نمی سے بے نقاب نہ کریں۔
- Refer to the vehicle manufacturer's service manual for specific safety procedures related to the vehicle's electrical system.
3. پیکیج کے مشمولات
تصدیق کریں کہ تمام اشیاء پیکیج میں موجود ہیں:
- ES 725 Battery/Starting/Charging Tester unit
- صارف دستی (یہ دستاویز)
- Test leads with clamps
4. مصنوعات کی خصوصیات
The ES 725 Tester offers the following key features:
- Tests battery condition and the starting/charging system.
- Battery test results include State of Health percentage, State of Charge percentage, and actual CCA capacity.
- Removes surface charge prior to battery test for accurate results.
- 2-line LCD display available in 7 languages.
- CCA test range: 40 - 2000 CCA.
- Tests 6V and 12V batteries.
- Tests 12V and 24V charging systems.
5. سیٹ اپ
Before operating the ES 725 Tester, ensure it is properly set up:
- طاقت کا منبع: The unit is battery-powered. Ensure a fresh 9-volt battery is installed in the designated compartment.
- ٹیسٹ لیڈز کو جوڑیں: سرخ cl منسلک کریںamp مثبت (+) بیٹری ٹرمینل اور سیاہ cl تکamp to the negative (-) battery terminal. Ensure a secure connection.
- ابتدائی ڈسپلے: The LCD will power on and display the initial menu.
6. آپریٹنگ ہدایات
The ES 725 provides a guided test sequence. Follow the on-screen prompts.
6.1. بیٹری ٹیسٹ
- Connect the tester to the battery terminals as described in the Setup section.
- Select "Battery Test" from the main menu using the navigation buttons.
- بیٹری کی کولڈ کرینکنگ ان پٹ کریں۔ Amps (CCA) rating when prompted. This information is typically found on the battery label.
- The tester will automatically remove surface charge and perform the test.
- Results will display State of Health (SOH), State of Charge (SOC), and actual CCA capacity.
6.2. Cranking Volts Test
- Ensure the tester is connected to the battery.
- Select "Cranking Volts Test" from the menu.
- Follow the on-screen instructions to crank the engine for a short period (typically 5-10 seconds). Do not start the engine.
- ٹیسٹر والیوم کی پیمائش کرے گا۔tage drop during cranking and display the results, indicating the starter's performance.
6.3 چارجنگ سسٹم ٹیسٹ
- With the tester connected, select "Charging System Test."
- Start the vehicle's engine and allow it to idle.
- The tester will measure the alternator's output voltage and check for AC ripple, which can indicate faulty diodes.
- Follow any additional on-screen prompts, such as increasing engine RPM, if requested by the tester.
- The results will indicate the health of the charging system.
7 دیکھ بھال
To ensure the longevity and accuracy of your ES 725 Tester:
- صفائی: یونٹ کو نرم، خشک کپڑے سے صاف کریں۔ کھرچنے والے کلینر یا سالوینٹس کا استعمال نہ کریں۔
- ذخیرہ: ٹیسٹر کو براہ راست سورج کی روشنی اور انتہائی درجہ حرارت سے دور ٹھنڈی، خشک جگہ پر اسٹور کریں۔
- بیٹری کی تبدیلی: Replace the internal 9-volt battery when the low battery indicator appears on the display.
- Lead Inspection: وقتا فوقتا ٹیسٹ لیڈز اور cl کا معائنہ کریں۔amps for damage. Replace if any wear or damage is observed.
8 خرابیوں کا سراغ لگانا
| مسئلہ | ممکنہ وجہ | حل |
|---|---|---|
| ٹیسٹر آن نہیں ہے۔ | Dead or improperly installed 9V battery. | Replace the 9V battery or ensure it is correctly installed. |
| غلط ٹیسٹ کے نتائج۔ | Poor connection to battery terminals; incorrect CCA input; battery surface charge not removed. | cl کو یقینی بنائیںamps are clean and securely attached. Verify correct CCA input. The tester automatically removes surface charge, but ensure battery has rested for a few minutes if recently charged. |
| ڈسپلے پر "خرابی" کا پیغام۔ | بیٹری جلدtage too low; connection issue; internal fault. | بیٹری والیوم چیک کریں۔tage (if extremely low, tester may not function). Re-check connections. If problem persists, contact support. |
9. وضاحتیں
- ماڈل: 725
- بیٹری والیومtagای مطابقت: 6V، 12V
- چارجنگ سسٹم والیومtagای مطابقت: 12V، 24V
- CCA Test Range: 40 - 2000 CCA
- ڈسپلے: 2 لائن LCD
- طاقت کا منبع: 9 وولٹ کی بیٹری
- طول و عرض (L x W x H): 27.9 x 25.4 x 7.6 سینٹی میٹر (تقریبا)
- وزن: 771 جی (تقریبا))
10. وارنٹی اور سپورٹ
وارنٹی کی معلومات یا تکنیکی مدد کے لیے، براہ کرم صنعت کار کے اہلکار سے رجوع کریں۔ webسائٹ یا ان کے کسٹمر سروس ڈیپارٹمنٹ سے رابطہ کریں۔ خریداری کے ثبوت کے طور پر اپنی خریداری کی رسید اپنے پاس رکھیں۔
مینوفیکچرر: الیکٹرانک خصوصیات
برانڈ: ES
ماڈل: 725