لیویٹن 1547

لیویٹن 15 Amp 125 Volt Industrial Grade Straight Blade Grounding Connector (Model 1547)

صارف دستی

پروڈکٹ ختمview

لیویٹن 15 Amp, 125 Volt, Straight Blade, Industrial Grade, Dustguard, Grounding Connector, Model 1547, is engineered for demanding environments. Its rugged construction resists impact, sunlight, chemicals, and rough use. Key features include solid one-piece contacts for superior conductivity and an ergonomic, fluted-body design with a radial gripping edge for easy handling. The unique cord clamp accommodates a wide range of cord sizes, ensuring a secure grip without damaging the cord. This connector is designed to meet IP44 splash-proof and dust-tight standards. The Santoprene Husk material provides resistance to oil, acids, alkalis, and many industrial solvents, and is developed to withstand dusty and dirty environments, cracking, fading, and temperature extremes.

Leviton 1547 Industrial Grade Straight Blade Grounding Connector

Image: Leviton 1547 Industrial Grade Straight Blade Grounding Connector, Yellow.

اہم حفاظتی معلومات

انتباہ: الیکٹرک شاک یا آگ لگنے کا خطرہ۔ This product must be installed and used in accordance with national and local electrical codes. If you are unsure about any part of these instructions, consult a qualified electrician. Always disconnect power at the circuit breaker or fuse box before installing or servicing this product. Do not use this product if it appears damaged. This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm (Proposition 65 warning).

  • Always ensure power is OFF before installation or maintenance.
  • مخصوص الیکٹریکل ریٹنگز سے تجاوز نہ کریں (15 Amp، 125 وولٹ)۔
  • یقینی بنائیں کہ مناسب گراؤنڈ کنکشن بنائے گئے ہیں۔
  • بچوں سے دور رکھیں۔
  • Do not immerse in water. This product is splash-proof, not waterproof.

تنصیب کی ہدایات

Follow these steps for proper wiring and assembly of the connector:

  1. کیبل تیار کریں: Strip the outer jacket of your electrical cable to the appropriate length, typically 1 to 1.5 inches, exposing the insulated conductors (hot, neutral, ground). Strip approximately 1/2 inch of insulation from each conductor.
  2. کنیکٹر کو جدا کریں: Unscrew the housing of the Leviton 1547 connector to separate the body from the wiring module.
  3. کیبل ڈالیں: Thread the prepared cable through the cord clamp and into the connector body.
  4. وائر کنکشن: Connect the insulated conductors to the corresponding terminals on the wiring module.
    • سبز یا ننگی تانبے کی تار: Connect to the grounding screw (green).
    • سفید تار (غیر جانبدار): Connect to the silver screw.
    • Black Wire (Hot): Connect to the brass screw.
    Ensure all wire strands are securely under the screw heads and tightened firmly. Double-check that no stray wire strands are touching other terminals.
  5. Secure Cord Clamp: ہڈی کو سخت کریں۔amp screws to secure the cable, ensuring a firm grip without overtightening, which could damage the cord. The cord clamp prevents strain on the wire connections.
  6. Reassemble Connector: Carefully align the wiring module with the connector body and screw the housing back together until it is tight. Ensure no wires are pinched during reassembly and that the connector is fully sealed.

آپریشن

Once properly installed and assembled, the Leviton 1547 connector functions as a standard electrical plug. Insert the connector into a compatible 125 Volt, 15 Amp, straight blade receptacle (NEMA 5-15R) to establish an electrical connection. Ensure the connection is firm and secure. To disconnect, grasp the connector body and pull it straight out from the receptacle; do not pull by the cord.

دیکھ بھال

To ensure continued safe and reliable operation of your Leviton 1547 connector, perform the following maintenance:

  • باقاعدہ معائنہ: Periodically inspect the connector for any signs of wear, damage, cracks, discoloration, or exposed wiring. Check the cord clamp سختی کے لئے.
  • صفائی: The Dustguard design helps protect internal components from dust and moisture. Clean the exterior of the connector with a dry, soft cloth. Do not use harsh chemicals, solvents, or abrasive cleaners, as these can damage the Santoprene Husk material.
  • ماحولیاتی تحفظ: While designed for industrial use and resistance to various elements, avoid prolonged exposure to extreme conditions beyond its specifications.
  • متبادل: If the connector shows any signs of significant damage, such as deep cracks in the housing, bent or corroded blades, or if the cord clamp is no longer securing the cable, replace the connector immediately. Do not attempt to repair damaged electrical components.

خرابی کا سراغ لگانا

If you encounter issues with your Leviton 1547 connector, refer to the following table for common problems and solutions:

مسئلہممکنہ وجہحل
منسلک ڈیوائس پر کوئی طاقت نہیں ہے۔Loose wire connection inside the connector or at the receptacle.Disconnect power at the circuit breaker. Carefully disassemble the connector and re-check and tighten all wire connections. Ensure the receptacle is functioning correctly.
Connector feels hot during useOverload on the circuit, poor wire connection, or damaged connector.Immediately disconnect power. Ensure the connected device does not exceed the connector's 15 Amp rating. Inspect for loose connections or visible damage. If damage is present, replace the connector.
Connector does not fit into the receptacleIncompatible plug or receptacle type.Verify that the receptacle is a standard 125 Volt, 15 Amp, straight blade type (NEMA 5-15R). This connector is not designed for other receptacle types.
Visible damage to the connector (cracks, exposed wires)Physical stress, impact, or chemical exposure.Replace the connector immediately. Do not use damaged electrical equipment as it poses a severe safety risk.

تکنیکی وضاحتیں

فیچرتفصیلات
برانڈلیویٹن
ماڈل نمبر1547
Ampایجری15 Amps
والیومtage125 وولٹ
کنیکٹر کی قسمStraight Blade, Grounding
پلگ کی قسمType B or Type NEMA 5-15
قطب کی تعداد2
تاروں کی تعداد3
پروڈکٹ گریڈصنعتی
موادCopper (contacts), Santoprene Husk (body)
رنگYellow (Multi)
تفصیلات میٹNEMA, IP44 (Splash proof and dust-tight)

وارنٹی اور سپورٹ

This Leviton product is backed by a 10 سال کی محدود وارنٹی. This warranty covers defects in materials and workmanship under normal use. For specific details regarding warranty coverage, limitations, and how to make a claim, please refer to the official Leviton webسائٹ یا لیویٹن کسٹمر سروس سے براہ راست رابطہ کریں۔

For technical assistance, product inquiries, or support, please visit the official Leviton webسائٹ (www.leviton.com) or contact their customer support department. Contact information, including phone numbers and email addresses, can typically be found in the 'Support' or 'Contact Us' section of their webسائٹ

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.