سسکو PIM سیلولر پلگ ایبل انٹرفیس ماڈیول یوزر مینوئل

سسکو PIM سیلولر پلگ ایبل انٹرفیس ماڈیول

وضاحتیں

• سم لاک اور انلاک صلاحیتوں کو سپورٹ کرتا ہے۔
• بیک اپ مقاصد کے لیے ڈوئل سم سپورٹ
• مناسب فرم ویئر کے لیے آٹو سم ایکٹیویشن
• پبلک لینڈ موبائل نیٹ ورک (PLMN) کا انتخاب
• پرائیویٹ LTE اور پرائیویٹ 5G نیٹ ورک سپورٹ
• دو فعال PDN پروfiles سیلولر انٹرفیس پر
• IPv6 ڈیٹا ٹریفک کے لیے سپورٹ
• Cisco IOS-XE پر سیلولر سروس ایبلٹی خصوصیات

سیلولر PIM کو ترتیب دینے کے لیے ضروری شرائط

نوٹ

You must have the appropriate antennas and antenna accessories to complete your installation. Consult the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for suggestions on possible solutions.

• If the signal is not good at the router, place the antenna away from router in a better coverage area. Please refer to the RSSI/SNR values as displayed through show cellular <x/x/x> all or the LED of the pluggable modem.
• You must have cellular network coverage where your router is physically placed. For a complete list of supported carriers.
• You must subscribe to a service plan with a wireless service provider and obtain a Subscriber Identity Module (SIM) card. Only micro SIMs are supported.
• You must install the SIM card before configuring the Cellular PIM or router.
• The standalone antenna that supports GPS capabilities must be installed for the GPS feature to work when available on the PIM.

سیلولر PIM کی تشکیل کے لیے پابندیاں

• Currently, cellular networks support only user initiated bearer establishment.
• Due to the shared nature of wireless communications, the experienced throughput varies depending on the radio network capabilities, number of active users or congestion in a given network.
• Cellular bandwidth is asymmetric with the downlink data rate being greater than the uplink data rate, while on private cellular with TDD frequency band(s), it may be symmetrical.
• Cellular networks have higher latency compared to wired networks. Radio latency rates depend on the technology and carrier. Latency also depends on the signal conditions and can be higher because ofnetwork congestion.
• CDMA-EVDO, CDMA-1xRTT, and GPRS technology modes are not supported. 2G is only supported on the P-LTE-GB.
• Any restrictions that are part of the terms of service from your carrier.
• SMS—Only one text message up to 160 characters to one recipient at a time is supported. Larger texts are automatically truncated to the proper size before being sent.

خصوصیات تعاون یافتہ نہیں ہیں۔

The following features are not supported:

• On Cisco IOS-XE, TTY support or Line is not available on cellular interface as it was on IOS classic.
• On Cisco IOS-XE, explicit Chat script /Dialer string doesn’t need to be configured for the cellular interface as it was on IOS classic.
• DM log output to USB flash is not supported
• صوتی خدمات

سیلولر PIM اہم خصوصیات

The PIM supports the following major features:

اکثر پوچھے گئے سوالات

• س: کیا میں سسکو سیلولر پلگ ایبل انٹرفیس ماڈیول کے ساتھ کسی بھی قسم کے اینٹینا استعمال کرسکتا ہوں؟
  • A: No, it is recommended to use antennas and accessories specified in the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for compatibility and performance.
• سوال: کتنے PDN پرو؟files سیلولر انٹرفیس پر فعال ہو سکتا ہے؟
  • A: دو PDN پرو تکfiles can be active on the Cellular interface, depending on the SIM subscription and services.